FREQUENCY JAMMER SYSTEM
Abstract
This project presents the development and implementation of a Frequency Jammer System
designed for controlled signal interference in secure and research-oriented environments. The
system incorporates an ESP32 microcontroller for centralized processing and control, and
integrates key components such as RF modules, SMA antenna connectors, a CP2102 USB-toserial converter for programming and debugging, and status indicators via WS2812 RGB
LEDs. It is powered by a rechargeable battery system, managed through a TP4056 charging
module and voltage regulators to ensure power efficiency and stability. The construction
phase began with simulation and testing on a breadboard, followed by circuit soldering onto
Vero boards and final enclosure into a portable, field-ready casing. Throughout development,
attention was given to optimizing RF signal transmission, power distribution, and
communication between modules using UART and SPI protocols.
The system’s performance was validated by testing signal disruption within a defined
frequency range, highlighting low-latency response from control input to signal output. Key
challenges included microcontroller stability under RF load, component heat management,
and ensuring reliable wireless signal output. These were addressed through hardware
replacement, circuit refinement, and improved grounding and shielding practices. This
jammer system demonstrates practical implications in testing wireless system vulnerabilities
in labs, educational settings.
Full-Text Access Notice
In accordance with the NERD Policy on promoting peer-reviewed publication, public access to the full text of a project, thesis or dissertation is restricted for three years, allowing the author and supervisors sufficient time to pursue peer-reviewed publication.
During this period, researchers with legitimate academic or research purposes may request authorisation directly from the author to enable NERD to release the indexed full texts of the work using the form below.